Answer
It's sediment from you water heater. The chlorine and other chemicals put into the water to purify it, settle in the water heater when your water isn't being used. When you use your hot water your water heater starts filling with cold water which shakes up the sediment in the bottom. when the hot water is running the loose particles can get into your hot water lines. They can pass until they hit the screens or airators in your lines causing build up. The best solution is to replace your water heater, take off all airators and shower heads clean them out and flush out the hot water system before putting them back on.
Answer
White particles in water can be caused by calcium if the water is considered hard water. It can also be plastic dip tube that is inside the hot water heater.
Answer
Check your water heater to see if it has a bad dip tube. The DIP TUBE is a plastic tube that sends the incoming cold water to the bottom of the tank to prevent it from mixing with the hot water going to your faucets. For a period of time between 1993 & 1997, most water heater manufacturers were supplied with defective dip tubes from the same manufacturing company. The problem caused the dip tube to disintegrate slowly, and the particles and chunks to clog up faucets, aerators, etc. There was a class action lawsuit that provided dip tube replacement for those who signed up in time, but that program is now over. Many people didn't hear about the problem in time even though the media reported it on new shows and in newspapers many times for several years.
First answer by ID0000000000. Last edit by Redwood. Contributor trust: 172 [recommend contributor]. Question popularity: 186 [recommend question]





